Virtual Prototyping Application using Computer Aided Engineering in Plastic Product Manufacturing

Ahmad Juang Pratama

Abstract


Efficiency in using plastic injection technology, especially within small to medium enterprises, is a very difficult target to achieve.  One of the contributing factor to the high cost of  using this technology is the trial and error nature of constructing the plastic mold which directly affect machninig cost and longet production cycle time.  The trial and error scheme can be significantly reduced and even eliminated with the application of concurrent engineering method supported by virtual prototype based CAD (computer aided design) and CAE (computer aided engineering).  Virtual prototype technology gives way to product analysis, design and material optimization, and proses parameter optimization prior to implementing the manufacturing process.  Therefore, we can anticipate all potential manufacturing flaws during the design process.  It is then expeceted to reduce machning and production process cost, increase product quality to boost up Company’s competitive advantage.

Full Text:

PREVIEW DOCUMENT


DOI: http://dx.doi.org/10.36722/sst.v1i2.30

Refbacks

  • There are currently no refbacks.


LP2M (Lembaga Penelitian dan Pengembangan Masyarakat)

Universitas AL-AZHAR INDONESIA, Lt.2 Ruang 207

Kompleks Masjid Agung Al Azhar

Jl. Sisingamangaraja, Kebayoran Baru

Jakarta Selatan 12110

Visitor

 This work is licensed under CC BY 4.0